Let the spackle dry according to the manufacturer’s instructions apply another coat if necessary.Remove excess spackle with the putty knife.Angle the knife about 45 degrees and run it in downward motions until the hole is filled. Prep the area by removing loose drywall around the hole’s perimeter.Patching small holes with either product is a similar process, with a few exceptions.įor holes in drywall or plaster that are smaller than a half-inch, opt for a premixed spackle and follow these steps: If you’re mixing up your own DIY spackle or joint compound with water and a powder mix, only make as much needed for the job at hand. It’s important to work quickly with both joint compound and spackle, and you should keep either product covered when not in use. Both products can dry out quickly during use as they’re exposed to air. Spackle (especially the lightweight variety) dries too quickly for the kind of coverage needed to make big repairs or install drywall-jobs which definitely call for joint compound. You’re better off going back to the hardware store for more drywall mud instead. On the other hand, if you’re all out of joint compound but have what looks like enough spackle to patch a large hole or finish your drywall installation, hold off. Just be aware that joint compound runs the risk of shrinking, which calls for multiple coats and a longer dry time-sometimes up to 24 hours. Got a tub of joint compound left over from a previous renovation? Feel free to substitute drywall mud for spackle for small drywall repairs. joint compound relatively straightforward. Spackle isn’t suited for this purpose because its quick-drying nature gives you less working time, which makes determining when to use spackle vs. With a little bit of finish work, the joint compound helps create a smooth surface with undetectable seams. A major difference between spackle and joint compound is the latter’s frosting-like consistency, whereas spackle is thicker.ĭuring drywall installation, contractors affix large sheets of gypsum board to a wall’s framing, apply drywall tape to the boards’ seams, and then cover the tape with joint compound. Joint compound (also known as “drywall mud” or simply “mud”) is comprised mainly of gypsum dust and can be bought in pre-mixed tubs, like spackle. Joint compound is most often used when hanging new drywall. Spackle dries more quickly with less shrinkage than joint compound-and that fast dry time (usually about 30 minutes) means you can sand and paint over the filled flaws almost right away. It’s used to fill small dings and dents, like nail holes, in walls. When making minor repairs to plaster or sheetrock, spackle is the way to go. Spackle, made of gypsum powder and binders, has a gooey paste-like consistency and is sold pre-mixed in tubs. Spackle is generally intended for repairing minor damage to drywall or plaster. If you’re about to tackle wall installation or repair, read on for the 411 on joint compound vs. The similarities end there, however, as they have various formulations that affect factors like dry time, shrinkage, and project scope. Is joint compound the same as spackle? Both popular putties are used in wall and ceiling repair and construction, and they look almost identical to the untrained eye.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |